Versacutter - Mobile Waterjet Cutting System0 pages

hydraulic
versacutter
Jet Edge’s Hydraulic Versacutter is a portable abrasivejet cutting
and beveling system. Rigid and flexible tracks allow the Hydraulic Versacutter to operate on flat or curved surfaces. The system is
used in a variety of cutting applications including pipelines, steel
reinforced concrete, reactor vessels and fabricated metal structures. It is especially suited for cutting in hazardous zones where
flames and heat are restricted.
The Versacutter carriage is a sealed unit that contains a hydraulic
motor. The hydraulic motor is connected to a gear reducer and a
drive sprocket. The sprocket engages the track to drive the
carriage along the track. Guide wheels support the carriage by
clamping it onto the track. A lever retracts the drive sprocket so
the drive unit can be positioned freely on the track and extends
the drive sprocket to engage the holes in the track. The carriage
has several clamps and tubes to adjust the position of a cutting
head.
The Versacutter includes two 8’ sections of track; one rigid, one
flexible. Additional track sections can be connected up to any
desired length, limited only by the reach of the support equipment hoses. Track sections are bolted together for extended
cuts. The rigid track is used of flat surfaces. The track is stiffened with two support rails. Mounting plates can be attached to the support
rail allowing the track to be bolted to a surface. The flexible track is used on cylinders and undulating surfaces. A winch is mounted to
one end of the track. A cable connects to the end of the track and the winch. The flexible track is mounted to standoffs and magnetic
standoffs; the magnetic standoffs work on ferrous surfaces.
A pneumatic delivery system meters the abrasive from the hopper to the cutting head. The micrometer controlled slidegate measuring
device features a large readout dial and a positive setting lock for accurate and repeatable abrasive delivery. The hopper holds up to 400
pounds of abrasive for hours of uninterrupted cutting. Quick setup and maneuverability are achieved by mounting the hopper on
pneumatic tires, and the weight-saving design enables operation in difficult overhead and vertical applications.

Rev. 7/2011
1

Carriage Dimensions
Height:
Width:
Length:
Carriage Weight:
Track Weight:
Magnetic Standoff:
Movement Speed:
Hydraulic Supply
Pressure:
Flow:

9-1/2 in (241 mm)
9-1/32 in (230 mm)
14-7/8 in (378 mm)
23 lb (10.4 kg)
32 lb (14.5 kg) per 96 in (2438 mm) track section
70–80 lb (32–36 kg) holding power
0–7.5 ipm (0–190 mm/min)
1500 psi (103 bar)
1–4 gpm (4.5–18.2 lpm)

MADE IN THE

12070 43rd St. N.E. St. Michael, MN 55376 USA

powered by jet edge!
The Riding Deckblaster
is powered by a
Jet Edge waterjet
intensifier pump.
Model iP55-280DS

www.jetedge.com
+1-763-497-8700 | 1-800-JET-EDGE
sales@jetedge.com