Water Jet Pipe Cutter0 pages

Pipe cutter
A Cut Above
Suitable for hazardous environments:
• Cuts virtually any material without heat or flames
Track Options:
• 3, 5 and 10 linear-foot tracks
• Low profile, rigid and vacuum tracks available
• Pipe track: 6–60 inches (152–1524 mm)
Movement Speed:
Varies due to several ranges of gear reducers
Head Manipulator
• Drive unit adapts for use with straightline
track or pipe cutting bands
• Reversible drive motor with interchangeable gear drive
• Precise speed control for accurate cutting feed rates
• Center line mounting of abrasive cutting head
• Adjustable angle for beveling cuts
Permalign® II Abrasive Head
Length
10.94 in (27.8 cm)
Weight
4.00 lbs ( 1.8 kg)
Operating air pressure (min) 60 psi (4 bar)
Water pressure (max)
60,000 psi (4100 bar)
Orifice range
.005 - .021 in (.127 - .53 mm)
Nozzle range
.020 - .065 ID (.508 - 1.65 mm)
Max flow rate
2.1 gpm (7.95 lpm)
High Flow Abrasive Head
(for cutting thicker material or multiple layers)
Length
7.55 in (19.1 cm)
Weight
4.00 lbs ( 1.8 kg)
Operating air pressure (min) 60 psi (4 bar)
Water pressure (max)
45,000 psi (3100 bar)
Orifice range
.020 - .036 in (.51 - .91 mm)
Nozzle range
.095 - .125 ID (2.41 - 3.18 mm)
Max flow rate
5.1 gpm (19.04 lpm)

Jet Edge’s Pipe Cutter is a hydraulically controlled portable abrasivejet cutting
system designed especially for cutting pipelines, reinforced concrete and metal
structures. The Pipe Cutter can operate horizontally or vertically. A specially
designed track allows the Pipe Cutter to clamp to standard sized pipe (6”-60”
diameter) for pipe cutting operations. The Pipe Cutter also can be attached to a
variety of tracks for cutting flat or curved surfaces for linear cutting applications.
The Jet Edge Pipe Cutter system includes a Pipe Cutter carriage, hydraulic drive
assembly, abrasivejet, abrasive hopper, abrasivejet mounting hardware, control
panel, remote UHP control assembly and hoses. For standard operation, it requires
a mobile intensifier pump to supply UHP water, an air compressor, hydraulic power,
track, and orifices and nozzles.

Abrasive Delivery System
• Durable steel design
• Two-wheel pneumatic tires with rigged frame
• Air-regulated metering valve
• Delivery rate: up to 3 lb (1.36 kg)/minute
Required Equipment
• A mobile intensifier pump to supply UHP water
• Air compressor to supply abrasive hopper
• Hydraulic power to operate support equipment
• Track (see track options)
• Orifices and nozzles to shape UHP water stream

powered by jet edge!
The Pipe cutter
is powered by a
Jet Edge waterjet
intensifier pump.

Rev. 7/2011
1

Model iP55-280DS

MADE IN THE

12070 43rd St. N.E. St. Michael, MN 55376 USA

www.jetedge.com
+1-763-497-8700 | 1-800-JET-EDGE
sales@jetedge.com