ECO-JET PTO Pump0 pages

eco-jet PTO
waterjet pump
An industry-first, the Eco-Jet PTO utilizes a tractor* PTO to produce up to 1
gpm of 55,000 psi ultra-high pressure (UHP) water for precision cutting,
cleaning and surface preparation applications.
Unlike traditional industrial waterjet pumps, the Eco-Jet PTO requires only
a standard 120 V 60 Hz power source and a suitable tractor, making it
practical for farm machine shops and shops with a limited power supply.
Advantages
· Highly Affordable
· Uses Standard Household Power
· Available for 540 rpm and 1000 rpm PTO
· Available for Category 1 and 2 Three-Point Hitches
· Easy to maintain
· Powers any manufacturer’s waterjet system!**
* Tractor Sold Separately
** Waterjet table or tool must be capable of sending a
pressure relief signal to the pump.

Specifications
Power:
Output Pressure:
Flow Rate:
Maximum Orifice:
Power Supply:
LWH:
Weight:

540 rpm and 1000 rpm PTO
producing a minimum of 50hp
55,000 psi (3800 bar) continuous
1 GPM (3.8 L/min)
.015 in (.38 mm)
120 V 60 Hz
35.75 inch x 39.54 inch x 35.43 inch
(1004 mm x 908 mm x 900 mm)
580 lb (263 kg); approximate

Standard Features
· Attenuator to reduce pressure fluctuations
· Liquid-filled pressure gauges
· UHP safety shielded tubing
ATTENUATOR

Construction
· Rugged all-steel welded framework
· NEMA 12/13 rated electrical enclosure
Environmental Requirements
· Temperature: Above freezing to 95ºF (0º-35ºC)
· Relative Humidity: Non condensing, maximum 95% at 95ºF (35ºC)

Rev. 9/2013

Tractor Requirements
· 540 rpm or 1000 rpm PTO producing a minimum of 50hp
· Category 1 or 2 Three-Point Hitch

MADE IN THE

12070 43rd St. N.E. St. Michael, MN 55376 USA

PLUNGER PUMP & HIGH
PRESSURE ASSEMBLY

Low-Pressure Water Requirements
· Type: Pretreated, <100 TDS, PH 6-8, Silica <15PPM
· Supply Requirements:
Feed Water: 4.5 to 5 GPM (17-19 lpm)
Minimum pressure 60 psi (4.2 bar)
Maximum temperature 70ºF (21ºC)
· On-board filtration to 0.45 micron

www.jetedge.com
+1-763-497-8700 | 1-800-JET-EDGE
sales@jetedge.com