ECO-JET Direct Drive Waterjet Pump - 30HP, 60KSI0 pages
eco-jet
waterjet pump
Energy efficient and economical, Jet Edge’s ECO-JET direct drive positive
displacement waterjet pump produces 1 GPM (3.8 L/min) of 55,000 psi (3800
bar) ultra-high pressure water for precision waterjet cutting and surface
preparation applications. Like all Jet Edge products, the ECO-JET features Jet
Edge’s signature rock-solid construction for lasting performance.
Advantages
· Energy-efficient and eco-friendly - Uses up to 40% less electricity than
a 50hp pump, but produces same output!
· Economically priced without sacrificing quality.
· Easy to maintain.
· Powers any manufacturer’s waterjet system!*
* Waterjet table or tool must be capable of sending a
pressure relief signal to the pump.
Specifications
Power:
Output Pressure:
Flow Rate:
Orifice:
Power Supply:
LWH:
Weight:
30HP (22kw)
55,000 psi (3800 bar) continuous
1 GPM (3.8 L/min)
.015 in (.38 mm)
3-Phase, 460 VAC (60Hz), 35AMP
50 inch x 32 inch x 46 inch
1270 mm x 820 mm x 1170 mm
1500 lb (680 kg); approximate
Standard Features
· High-efficiency TEFC motor
· 1800 nominal motor speed (rpm)
· User serviceable attenuator to reduce pressure fluctuations
· Liquid-filled pressure gauges
· UHP safety shielded tubing
· UL listed industrial control panel
· Automatic safety pressure relief valve
· Automatic safety pressure bleed-down valve to relieve pressure from
system.
· Integrated power distribution panel with system disconnect
· On-board pressure booster to ensure adequate water supply pressure
Construction
· Rugged all-steel welded framework
· NEMA 12/13 rated electrical enclosure
Rev. 2/2014
Environmental
· Ambient Room Temperature: 50°–95° F (10°–35° C)
· Relative Humidity: Non condensing, maximum 95% at 95ºF (35ºC)
MADE IN THE
12070 43rd St. N.E. St. Michael, MN 55376 USA
ATTENUATOR
PLUNGER PUMP & HIGH
PRESSURE ASSEMBLY
Electric Motor
· Motor Output: 30 hp (22 kw)
· Motor Type: High Efficiency TEFC electric motor
· Full load current: 35A @460VAC (60 Hz)
50A @380VAC (50 Hz)
70A @230 VAC (60 Hz)
Low-Pressure Water
· Type: Pretreated, <100 TDS, PH 6-8, Silica <15PPM
· Supply Requirements:
Coolant Water: 4 GPM (19 lpm)
Feed Water: 4.5 to 5 GPM (17-19 lpm)
Minimum pressure 60 psi (4.2 bar)
Maximum temperature 70ºF (21ºC)
· On-board filtration to 0.45 micron
www.jetedge.com
+1-763-497-8700 | 1-800-JET-EDGE
sales@jetedge.com