IP36-80DS DIESEL WATERJET PUMP0 pages

ip36-80ds
intensifier pump
Intensifier
· Output Pressure: 36,000 psi (2500 bar) or 40,000 psi (2757 bar) continous
· Number of intensifiers: 1
· 12:1 Intensification ratio
· Flow rate: 1.8 gpm (6.8 L/m) at 36,000 psi
or 1.6 gpm (6.05 L/m) at 40,000 psi
· Maximum Rated Orifice: .022 in (.56 mm) at 36,000 psi
or .020 in (.51 mm) at 40,000 psi
Engine
· Engine output: 80 hp
· Engine type: Cummins 4 cylinder turbocharged diesel
(meets Tier 3 certification)
· Fuel Tank: 27 U.S. gal (100 L)
· Cooling: Air cooled circulating water (radiator)
Hydraulic
· Pump type: Axial piston, variable displacement, pressure compensated
· Pressure rating: 3,200 psi (220 bar)
· Cooling: Air over oil heat exchanger
· Filtration: 10 micron kidney loop; 13 gpm at 1800 rpm (49 L/m)
· Fluid capacity: 25 U.S. gallons (95 L)
· Fluid type: Standard: medium grade turbine ISO
Standard Features
• A Programmable Logic Controller (PLC) operates the electronic timing
of the intensifier cycle
• 1.0 quart (0.9 liter) high pressure attenuator stabilizes operating pressure
• Automatic safety pressure bleed-down valve relieves pressure from system
• On-board Water Prefilter to 1 micron
• Hydraulic accumulator dampens hydraulic fluid pulsations
• Full flow hydraulic filtration to 10 micron increases hydraulic component life
• Air cooled hydraulic fluid
• Safety shutdown systems
• Skid design

Rev. 10/2013

Optional Features
• CE Mark

MADE IN THE

12070 43rd St. N.E. St. Michael, MN 55376 USA

Physical size
· Length: 88 inches (2235 mm)
· Width: 64 inches (1625 mm)
· Height: 65 inches (1650 mm)
· Weight: 3,500 lb (1590 kg) dry
Environmental
· Ambient temperature: 50-95ºF (10-35º C)
· Relative humidity: Non condensing,
maximum 95% at 100ºF (38ºC)
Low Pressure Water
· Input Pressure: Minimum pressure 40 psi
(3 bar) at 7 gpm (26 L/m)
· Input temperature: Maximum temperature
70ºF (21ºC)
· Filtration: Two filters, 10 micron and 1 micron

www.jetedge.com
+1-763-497-8700 | 1-800-JET-EDGE
sales@jetedge.com