021030E0 pages

Issue 02-13*

240-30

SWING CLAMP CYLINDERS
threaded body with overload protection, single-/double-acting, pmax. 500 bar
Designs:

B1

Mounting:
B1
B2
B3
C1
C2

B3

B2

C1

C2

Oil supply connection:

manifold ................. G1/4 threaded port ......... lateraly
manifold ................. manifold with O-ring ....... below
manifold/built-in ..... G1/4 threaded port ......... lateraly
built-in .................... G1/4 threaded port ......... below
built-in .................... G1/4 threaded port ......... below

Webcode: 024030
We also design
and manufacture
special designs

Description:

Operating conditions:

Swing clamp cylinders release the clamping
point on the workpiece. With this, it is easy
to change the workpiece.

For any risk of exceeding the permitted
volume flow a throttle check valve must
be interposed into the oil supply line
(see data sheet 700-15). Counter-hold
the clamp arm when tightening or loosening
the counter nut in order to prevent torque
transfer to the piston rod and to avoid
damage to the ball guide.

This hydraulic swing clamp cylinder operates
as single-acting or double-acting pull cylinder,
whereas part of the stroke is used to rotate
the piston. The model with 0° swing angle
operates only vertical as pull cylinder.
To guarantee a long lifetime the cylinders
have an integrated metal wiper as standard.
For oil supply, the cylinders are equipped with
threaded port and manifold connection with
O-ring for drilled channels.
You can select between right or left turning
models with various standardized swing
angles.
The integrated overload protection protects
the swing mechanism from damage due
blockage of the rotation or improper
assembly of the clamp arm.

Variations with 0°, 30°, 45°, 60° and 90°
swing angles are available. The permitted
operating pressure is depending from the
clamp arm length.
Except from standard clamp arms also
special clamp arms can be assembled.
The maximum operating pressure of 500 bar
does not apply for each clamp arm length.
For details about the permitted operating
pressure, refer to page 4.
The safety instructions for swing
clamp cylinders in our catalogue
or on our website and the current
accident prevention regulations
must be considered.

Connections:
G1/4 threaded port
Manifold with O-ring

Advantages:
Protecting metal wiper
Integrated overload protection
Oil supply through drilled channels
or threaded port connection
Fixture can be easily loaded
and unloaded
Easy to assemble with
self designed clamp arms
Standard and special clamb
arms available (see page 4)
Various contact bolts available
(see data sheet 1000-1)

Application example:
0° only clamping
90° swing motion
left turning
(basic position)

90° swing motion
right turning
(basic position)

HYDROKOMP

®

Hydraulische Komponenten GmbH
Siemensstraße 16, 35325 Mücke (Germany)
Phone: +49 6401 225999-0
Fax:
+49 6401 225999-50
E-mail: info@hydrokomp.de
Internet: www.hydrokomp.de
240-30 / 02-13 *Subject to change without notice, compare issue no. at www.hydrokomp.de.

1