CBS - Electro-mechanical belt alignment sensors for conveyors0 pages

Product Information

ELECTRO-MECHANICAL BELT ALIGNMENT SENSOR

ATEX-ApprovedEx II 1D Ex tDA20 ( Ex iaD) T125C IP 66

The CBS2 is an electromechanical system to detect the misalignment of a conveyor belt. It operates a non-mercury tiltswitchwhen the belt is misaligned. Two outputs are given at 15кand 30which can be used as alarm and stop signals respectively. 2 types of contact roller are availableMountedon a stainlesssteelbearing stainlesssteel304 or nylon cylinderMountedon shaft nylon cylinder The self-assembly adjustable support system is manufactured from stainless steel. >

An advantage of this system is the low contact force between theroller and the belt Жsimply the weight of the roller. It withstands prolonged contact without damage to the roller. The sensors are normally installed in pairs, one at each side ofthe machine, and up to 4 sensors for each CBS controller i.e. 2 at the drive end & 2 at the tension end. The sensors are designed for applications in ATEX areas by connection to the CBS2V0A control box but can also be connected directly to a PLC or a small interface relay.Detailed specification, wiring diagrams and installation/operating instructions available immediately upon request. >
Please refer to instruction manual for correct installation . Information subject to change or correction. May 2007 . 4B BRAIME ELEVATOR COMPONENTS LTD HunsletRoad, Leeds, LS10 1JZ, UKTel:+44 (0) 113 246 1800 Fax: :+44 (0) 113 243 5021 4b-uk@go4b.com >

www.go4b.com