Analog Servo Drive BE15A8-H0 pages

Analog Servo Drive BE15A8-H
Description
Power Range
Peak Current 15 A
Continuous Current 7.5 A
Supply Voltage 20 - 80 VDC
The BE15A8-H PWM servo drive is designed to drive brushless DC motors at a high switching frequency. A single red/green LED indicates operating status. The drive is fully protected against over-voltage, under voltage, over-current, over-heating and short-circuits across motor, ground and power leads. Furthermore, the drive can interface with digital controllers or be used stand-alone, and requires only a single unregulated DC power supply. Loop gain, current limit, input gain and offset can be adjusted using 14-turn potentiometers. The offset adjusting potentiometer can also be used as an on-board input signal for testing purposes.
See Part Numbering Information on last page of datasheet for additional ordering options.
Features
..
Four Quadrant Regenerative Operation
..
DIP Switch Selectable Modes
..
Adjustable Current Limits
..
High Switching Frequency
..
Differential Input Command
..
On-Board Test Potentiometer
..
Offset Adjustment Potentiometer
..
Adjustable Input Gain
..
Selectable 120/60 Hall Commutation Phasing
..
Hall Velocity Mode
..
Drive Status LED
..
Velocity Monitor Outputs
MODES OF OPERATION
..
Current
..
Duty Cycle (Open Loop)
..
Hall Velocity
COMMAND SOURCE
..
±10 V Analog
FEEDBACK SUPPORTED
..
Halls
COMPLIANCES & AGENCY APPROVALS
..
UL
..
cUL
..
CE Class A (LVD)
..
CE Class A (EMC)
..
RoHS
Release Date:
9/1/2010
Revision:
2.01
ADVANCED Motion Controls · 3805 Calle Tecate, Camarillo, CA, 93012
ph# 805-389-1935 · fx# 805-389-1165· www.a-m-c.com
Page 1 of 8