Push-in Fitting Diaphragm Valves0 pages

SOLENOID VALVE

Push-in Fitting Diaphragm Valve

Features
・

・
・

・
・
・

No separate fittings required
Just insert tubing directly

Just insert plastic tubing into the ports to connect the valve.
No special preparation of the tubing is required, such as
enlarging the connection end.
For disconnection, simply pull out the tubing while pushing in
the port ends (collet).
The tubing can freely revolve even after insertion. This
prevents troublesome kinking and twisting that can occur
when you screw the other end of the tubing into a threaded
port using a conventional fitting.
Integral moulding eliminates the concern of leakage between
the fittings and the body.
Applicable to O.D. 2 mm PTFE/PFA tubing.
High chemical resistance due to PPS, FPM and PTFE wetted
materials.

How to Connect/Disconnect Tubing

Just insert the tubing into ports.

Just pull out the tubing while
pushing in the port ends (collet).

Use the QR code on the right or the link below to see
the movie “How to connect?”
www.takasago-elec.co.jp/movie/push-in_fitting.wmv

2014.07

TAKASAGO ELECTRIC, INC.
66 KAKITSUBATA, NARUMI-CHO, MIDORI-KU, NAGOYA, 458-8522 JAPAN
Tel +81-52-891-2301
Fax+81-52-891-7386
E-mail: info@takasago-elec.co.jp URL: http://www.takasago-fluidics.com/