e.bloxx A1 Universal measurement module for voltage, current, resistance, potentiometer Pt100 / Pt1000, TC and bridge0 pages
Universal Analog Measurement Module
The e.bloxx series is designed for industrial and experimental test systems requiring precise high speed measurement of electrical, thermal, and mechanical quantities in engine and component test beds. All units are based on a clean modular design, and easily connect to the wide variety of field devices used in todays test beds. Sample rates up to 5000 Hz and resolutions up to 19 bit are possible depending on the module and signal type used. Standardized communication protocols (Profibus-DP and Modbus-RTU) allow the e.bloxx family to work with a wide variety of application hardware and software. Adding an e.series Test Controller dramatically increases the systemҒs throughput and connectivity options. An e.series Test Controller is a data concentrator, communication gateway, and optionally a Programmable Automation Controller (PAC) with 100Mbps Ethernet, Profibus-DP, EtherCAT, or USB ports. EthernetTCP/IP >
RTD
1, 4, or 8 universal analog input channels
nnU
Voltage, current, resistance, Pt100, Pt1000, thermocouples, bridges >
nnI
nnRTD
nn1 digital input per channel
Status, tare, memory reset >
nn1 solid state relay output per channel
Status, alarm, limit value, tolerance band >
nnSignal conditioning
Linearization, digital filtering, averaging, scaling, minimum/maximum, arithmetic, alarm >
e.bloxx A1-1 e.bloxx A1-8 e.bloxx A1-4
RS 485 fieldbus interface
Profibus-DP, Modbus-RTU, ASCII >
nnOrder Information Additional Features
Product Article No. Accuracy 0.01 % e.bloxx A1-1 897428 e.bloxx A1-4 941418 e.bloxx A1-8 941519 AccessoriesConfiguration Software ICP 100 633214 Cold Junction Compensation e.bloxx Terminal CJC 111874 Interface Converter RS232 / RS485 ISK 200 229682 ISK 101 689326 ADC resolution and internal calculation accuracy of 19 bits Measuring rate up to 1000 samples/sec Linearization, scaling, and data formatting Data transmission up to 1.5 Mbps Up to 32 modules on a single two wire RS-485 interface PC-Software (ICP 100) for easy configuration of the modules Galvanic isolation of I/O signals, power supply, and communication interface Power supply 10 to 30 VDC DIN rail mounting (EN 50022 rail) Pluggable screw terminals for field, power, and communication connections Electromagnetic Compatibility according to EN 61000-4 and EN 55011 >
Gantner Instruments Test & Measurement GmbH www.gantner-instruments.com office@gantner-instruments.com Montafonerstrae 8 A-6780 Schruns / Austria T +43 (0) 5556 73784-410 F +43 (0) 5556 73784-419Industriestraߟe 12 D-64297 Darmstadt / Germany T +49 (0) 6151 95136-0 F +49 (0) 6151 95136-26 size="-1">