e.bloxx A3 Multi channel module for voltages (for current with an additional connector)0 pages
Multi-Channel Voltage Module
The e.bloxx series is designed for industrial and experimental test systems requiring precise high speed measurement of electrical, thermal, and mechanical quantities in engine and component test beds. All units are based on a clean modular design, and easily connect to the wide variety of field devices used in todays test beds. Sample rates up to 5000 Hz and resolutions up to 19 bit are possible depending on the module and signal type used. Standardized communication protocols (Profibus-DP and Modbus-RTU) allow the e.bloxx family to work with a wide variety of application hardware and software. Adding an e.series Test Controller dramatically increases the systemҒs throughput and connectivity options. An e.series Test Controller is a data concentrator, communication gateway, and optionally a Programmable Automation Controller (PAC) with 100Mbps Ethernet, Profibus-DP, EtherCAT, or USB ports. EthernetTCP/IP >
nnU
nn4 analog, galvanic isolated input channels
Differential voltage (10 V and ѱ2 V range) >
nnMeasuring rate 100 samples/sec with 4 active channels
Total rate 400 samples/sec >
nnDifferential inputs
Common mode voltage 100 VDC >
nnSignal conditioning
Digital filtering, averaging, scaling, minimum/maximum, arithmetic, alarm >
e.bloxx A3-1TC e.bloxx A3-4 TC
RS 485 fieldbus interface
Profibus-DP, Modbus-RTU, ASCII >
nnOrder Information: Additional features
Product Article No. Accuracy 0.01 % e.bloxx A3-1 235477 e.bloxx A3-4 237075 Accessoriese.bloxx Terminal 4C for the connection of current signals 229884 Configuration Software ICP 100 633214 Interface Converter RS232 / RS485 ISK 200 229682 ISK 101 689326 ADC resolution and internal calculation accuracy of 19 bits Measuring rate 100 samples/sec per channel (4 active channels) Filtering, scaling, and data formatting Data transmission up to 1.5 Mbps Up to 32 modules on a single two wire RS-485 interface PC-Software (ICP 100) for easy configuration of the modules Galvanic isolation of I/O-signals, power supply, and communication interface Power supply 10 to 30 VDC DIN rail mounting (EN 50022 rail) Pluggable screw terminals for field, power, and communication connections Electromagnetic Compatibility according to EN 61000-4 and EN 55011 >
Gantner Instruments Test & Measurement GmbH www.gantner-instruments.com office@gantner-instruments.com Montafonerstrae 8 A-6780 Schruns / Austria T +43 (0) 5556 73784-410 F +43 (0) 5556 73784-419Industriestraߟe 12 D-64297 Darmstadt / Germany T +49 (0) 6151 95136-0 F +49 (0) 6151 95136-26 size="-1">