Dispersing machine DMS0 pages

Fluid Kotthoff GmbH

Mixing Technology

Dispersing machine DMS
Machine design
The stirring shaft of the FLUKO DMS is directly coupled to or integrated in the motor shaft. This gives
the machine a very compact form. Normally, a seal housing connects the motor to the mixing section.

Drive
FLUKO Dispersing machines are equipped with standard 3 phase motors, in IP 55 and speeds from
1000 to 3600 r.p.m. depending on the frequency. Machines for
explosion proof areas compliant with ATEX standards are also available.
The DMS can also be equipped with polechanging motors,
geared motors or frequency converters for a continuous speed control
and variation.

stator
rotor

Configuration
The DMS can be mounted with the stirrer shaft verticle or horizontal.
When mounted vertically, the drive can be placed above or below the mixing
chamber. The flow direction of the products can be selected. The DMS is
mouted either on a base frame or into an existing plant via the motor mounting.
Depending on the application, the stirrer shaft can be sealed with lip seals,
stuffing box seals or mechanical seals. The seals can be equipped with complete
or partial cooling or pressure quench systems.

recirculation
through flow

Materials
All product contacting parts are made of high quality
1.4571 stainless steel (SS316Ti).
For hygenic applications the internal surfaces can
be electrolitically polished.

Mixing section
The rotor-stator system is available with differing pumping
and mixing capacities. The capacities are reached with variation of the rotor width,
the speed and the number of rotor/stator sets which make up the mixing
chamber units. Further variation of the capacity is possible by throttling the output, which at the same
time increases the recirculation and the dispersing effect within the machine.
The machines are available with up to 3 sequential chambers. The mixing housing is available
with a heating/cooling jacket. The DMS requires a continuous product feed, and is not self priming.
The inlet and outlet can be equipped with most standard connection systems,
eg. threaded unions, flanges or clamps.
The machine can also be configured with additional inlets for direct dosage of component products.
The rotor-stator system itself can operate without product.
The shaft sealing system can be configured for operating pressures of up to 16 bars.
The standard operating temperature extends to 120°C. Special versions are available to 300°C

··
··

Dispersing machine DMS
Page 1 of 2

Daniel-Eckhardt-Str. 44 · D-45356 Essen
Telephone +49 (0)2 01 8 35 73-0 · Fax -20
Fluid Kotthoff GmbH info@fluid-kotthoff.de · www.fluid-kotthoff.de