R

®

adi Power Pulse
The RF/Burst Power Meter
Extremely Fast · Robust · Flexible
An adequate power meter is indispensable to perform reproducible and reliable
RF power measurements. The RadiPower® Pulse offers a range of RF power
meters dedicated for RF/Burst power measurements. The RadiPower® Pulse
USB power heads are affordable, accurate and extremely fast. The RPR2006P
provides measurements over a frequency range from 9 kHz up to 6 GHz. The
RPR2018P measures over a frequency range of 80 MHz up to 18 GHz.
Extremely Fast
The RadiPower® Pulse USB power heads perform power measurements with a
maximum sampling speed of 1 million samples per second! By using such a
high sampling mode it is capable to measure RF Burst/Pulse signals with pulse
durations down to 2µsec and it can measure CW and RMS power as well.
Accurate
Next to speed, accuracy is another main requirement when performing RF
Burst/Pulse power measurements. The RPR2006P allows high precision RF
power measurements with a high dynamic range of over 65 dB. Both power
meters provide a basic accuracy of 0.25 dB and are way within requirements for
measurements in accordance to international EMC immunity standards.
Flexible
The RadiPower® plug-in card (USB1004A) contains 4 USB slots to connect a
maximum of four RadiPower® power heads of any combination and is designed
to fit into the RadiCentre® EMC test systems. Alternatively the RadiPower®
heads can be connected directly to a PC USB port.
‘Logging’ mode
The RadiPower® Pulse is not only able to measure extremely fast. Using the
‘Logging’ mode’ an RF power signal can be measured with a speed of 10ms
and logged into a graph for monitoring power over an infinitive time period.

Dijkstra Advice, Research & EMC Instruments B.V.
Vijzelmolenlaan 7 – NL-3447 GX Woerden
The Netherlands
Tel: +31 348 41 65 92
Fax: +31 348 43 06 45
Internet: www.dare.nl
E-mail: instruments@dare.nl
The Standard for Consultancy, (Re)design
and Training in RF EMC and Product Safety

‘Envelop trace’ mode
The ‘envelop trace’ mode can be used to visualize an RF/Burst signal using an
internal buffer that can store 4.000 samples, using 2.000 pre-trigger
measurements and 2.000 post-trigger measurements. The RadiPower® supports
‘edge’ or ‘level’ triggering modes and using this mode RF Burst signals can be
visualized in a very easy way. This unique function can be used to perform
different kind of RF Burst/Pulse measurements including the RI-114 Radar
Pulse power measurements in accordance to the Automotive Ford standard
EMC_CS_2009.
Software support
The standard RadiMation® FREE freeware control software fully supports the
RadiPower® measurement modes where the measurement parameters can be
configured and the results are graphically displayed or printed/exported. Beside
this RadiMation® EMC test software can be used to perform fully automated
immunity tests and control of the RadiPower® power meter. Using the
instrument command codes the RadiPower® can be used with any other
software control package.