GIS remote control0 pages

www.gis-ag.ch

GIS RADIO REMOTE CONTROL T80

Possible settings for the T80RX receiver
Programming a hold function for each receiver
relay. By pressing the button for a second time,
the relay is de-energized again
Neighboring receiver relays can be interlocked
together, or switching priorities can be set as well
Reprogramming of receiver, in order that only one
operational step is activated at the transmitter
buttons 1 - 6. The second step is set as inactive on
buttons 1 - 4 and transferred to buttons 5 and 6
(e.g. a button for slow or fast lifting)

GIS AG

Tel. +41 (0)41 984 11 33

Hebe- und Fördertechnik
Luzernerstrasse 50

Fax +41 (0)41 984 11 44
tel@gis-ag.ch

CH-6247 Schötz

www.gis-ag.ch

Subject to changes reserved

Programming up to ten PIN codes to prevent
unauthorized use of the hoist. Code entered
into the handheld transmitter at start-up
LED display of current battery condition
(green, red)
Control of 2 hoists with handheld transmitter: operation of No.1, No.2 or both at the
same time (synchronous)
A chain hoist can be controlled by up to
three handheld transmitters (for safety reasons,
not at the same time)
Easy replacement of a handheld transmitter
by using the log in function of the new
handheld transmitter
In case of interference, there is a choice of
68 other channels (from 433.075MHz to
434.775MHz)
To conserve battery power on the transmitter,
it is possible to set an automatic disconnection
after 2, 6 or 12 minutes
A delay can be set between the rst and second
action of the transmitter push button:
0.3s, 0.5s, 1s, 1.5s and 3s

07.09.9400.9605.1

Possible settings for
T80TX-10 transmitter