FPI Detector Accessories for Hydrogen Sulfide,Nitrogen Dioxide etc0 pages
GT
Detector accessories
Detector Controller
RC-1000
The detector controller is used to supply power and process data for the gas detector. It is based on
two-wire and three-wire systems.
Product model: GC-1010-AA/AE, GC-1010-CA, and GC-1020-AA/AE.
GC-1010 controller
GT-1020/1030/1031
Compared with traditional potentiometer, magnetic bar and one-way infrared remote control, RC100 reveals its advantage in remotely acquiring data and setting parameters. With the ability to
restore setting parameters, one RC-100 can be used for parameter setting and calibration for
several detectors.
TECHNICAL DATA
GT-1020/1030/1031
Industrial PC/DCS/PLC
Number of button
Unsafe area
Safe area
Safe area
Explosion-proof type
Intrinsically safe Exia IIC T4
<100mW
Operating humidity
Unsafe area
Two AAA batteries
Power consumption
4-20mA output
8
Battery
4-20mA output
(10-95)% RH (non-condensing)
Cone angle of infrared receiver
50°
Cone angle of infrared emitter
Schematic Diagram of Networking
(Networking based on wiring system)
Wireless data setting
128*128 STN LCD
LCD
50°
Dimension
One-key calibration
127.7mm×48mm×26mm (H × W × T)
标
准
气
体
Note: The whole system consists of a detector and a controller. The detector is responsible for sensing toxic and
harmful gas in the environment, and sending these signals to the controller or industrial computer in the safety zone
through (4~20)mA output.
SG-100
Explosion-proof wiring box
The explosion-proof box is used for all kinds of electrical connection industrial site with explosion
proof requirement. The box is also corrosion prevented and easy to use.
SG-100 can be integratively installed on GT detector to give
audible alarms and emits red flash light when gas concentration
detected exceeds. The locknut design ensures alarm can be
observed at any direction. It is full compatible with all other GT
series detectors except two-wire ones.
TECHNICAL DATA
TECHNICAL DATA
Explosion proof
Exd II B T6, Exd II C T6
Protection class
IP65/ IP66
Rated current
10/20/32/63/100A
Electrical interface
G1/2, G3/4, G1
Operating voltage
(15~30) V DC
Operating current
<30mA
Alarm sound
>85dB
Operating temperature
(-40~70)℃
0.3Hz/3Hz
Explosion-proof grade
Exdib IIC T6
Interface size
M20X1.5
Dimension
07
Alarm frequency
43mm×83mm
08
Flammable and Toxic Gas Detection