19.013.326 Servo-controlled solenoid valve NC, DN 130 pages

servo-controlled
normally closed (NC)
solenoid replaceable while medium circuit
remains untouched, solenoid rotatable 4x90°
(4 and 5)
suitable for hot water up to 90 °C
similar performance for AC or DC types
long term performance capability
optimized water hammer characteristic by
low noise emission according to EN 60730
high operating safety by the use of high
quality materials and 100% final testing of the
products

The manifold valve is equipped with two
separate inlets (4 and 5) of nominal diameter
DN 13. Both provide the main outlet 1. Thus,
the user has the possibility to change between
warm or cold medium, for example. Flow
regulators can be installed in both inlets.
Two other valve components of nominal
diameter DN 10 (2 or 3) offer additional flow
paths. A flow regulator or an orifice can be
applied into the valve seats to achieve a
defined flow limitation.
The valve components are servo controlled
and normally closed (NC).
Coil systems for common voltage
frequency ranges are available.

and

industrial appliances
air conditioning
agricultural implements
pollution equipment
dish washers
washing machines

typical performance curve

Electrical operating safety is achieved by
insulation class F and can be supported by an
integrated protective circuit.
By using high quality insulation materials,
continuous duty (100 % ED) at higher medium
temperatures is possible. Protection against
corrosion of inner parts exposed to the medium
is achieved by using stainless steel.

© copyright A.u.K. Müller, technical changes reserved

E0206

1