VesselCheck ST2: High Accuracy System meeting Customs & Excise Standards0 pages
Level Measurement
VesselCheck ST2
Non-Invasive Tank Level Measurement System
Data sheet : ST2/2012
24 Vdc /
110/230Vac
Reference
used by ST2
only
RS 485/
1..5V /
4..20 mA
Principle of Operation
The ST2 uses two small ultrasonic sensors bonded or clamped to the outside walls of the vessel - one on the bottom of the vessel and the
other on the side, to compensate for variations in sonic velocity and temperature. Signals from the transducers are fed into the processor and
displayed locally and/or output to the plant control system. The system calculates the height and volume of the liquid in the tank from the time
taken for the signal to be received from the liquid surface.
Features:
yy
yy
yy
yy
yy
yy
yy
Truly non-invasive sensing technique
Sensors bonded to outside of tank base and side wall
20 point calibration table
Optional local display & keypad
4..20mA / 1..5V analogue outputs
RS485 / 232 Modbus serial communications
ATEX / IECEx approved sensors for hazardous areas available
Benefits:
yy
yy
Fast, reliable and accurate tank contents measurement
Easy installation - no tank break-in, easy retrofit to existing tt
ttanks
yy No down-time during installation
yy No moving parts – little or no maintenance required
ATEX Sensor shown
TM
Excellence the World can Measure
TM
"