WHEEL DIAMETER MEASURING GAUGE IDK & IDK-BT SERIES0 pages

WHEEL DIAMETER MEASURING GAUGE
IDK & IDK-BT SERIES

Electronic gauge is designed for measuring wheel
rolling circle diameter. Measurements are made
directly on rolling stock without wheel set roll-out.
The measurement of the diameter is performed
according to the "three points" technique, without
the complete wheel coverage.
The gauge contains numeric display to show
the value of the wheel diameter. IDK-BT gauge
contains Bluetooth interface for transfer results into
wheel-set wear database management system.
BASIC TECHNICAL DATA
Name of parameter
Measurement range, mm
Measurement error, mm
Indication discreteness
Position of measurement, S, mm
Distance between axes of ball bearings (base), mm
and measurement range, mm
Display
Operating temperature, 0C
Power supply – built-in rechargeable battery
The number of measurements that can be taken before
battery recharge is not less than
Weigh, kg

Value
400…1400 or on request
±0.2
0.1mm, 0.01mm or 0.01 inch
on request
200±0.5 (400…950 mm) or
250±0.5 (600…1400 mm) or
300±0.5 (720…1400 mm)
build-in, LED
-5…+55
rechargeable batteries 2хAAA 1,2V
1000
0,5

OVERALL DIMENSIONS
Electronic gauge contains two ball supports to place the gauge onto the roll surface, two side magnet
supports to base the gauge to the wheel edge and a measuring tip.
There are a digital numeric display and control buttons on the front panel of the gauge. “Charge”
connector for charging device connection and Bluetooth indication LED are situated on the top panel
of the gauge.

Сertified according to ISO 9001:2008