Cross-Cut® Airless Spray Gun Nozzles0 pages

Cross-Cut® Airless Spray Gun Nozzles
Nozzles provide superior atomization and control when spraying
high-solids, viscous and other hard-to-atomize materials.
Finishers are continually challenged with maintaining
excellent product quality and coating performance
throughout each stage of their operations. In the past,
spraying high-solids, viscous and other hard-to-atomize
coatings and materials has been possible either by adding
solvents, heating the material or increasing fluid pressure.
The use of solvents adds cost and time to build the desired
film thickness. Plus, increasingly stringent environmental
regulations for reduced VOC emissions make this alternative
more prohibitive.
And increasing fluid pressure – in excess of 1000 psi – to
improve atomization creates overspray and bounceback.
This results in wasted coating material, increased equipment
wear and shop environment problems for other personnel.

Nozzle Design
Nordson Cross-Cut nozzles are designed to provide improved
atomization with a wide range of materials, including highly
viscous and difficult-to-atomize coatings. Cross-Cut nozzles
produce greater atomizing energy at a given fluid pressure,
compared to conventional airless spray nozzles. Excellent
atomization is achieved at reduced fluid pressure, resulting
in a softer, low-velocity spray which helps minimize dripping,
material waste and equipment wear for maximum
coating efficiency and material utilization.

Meets Varying Requirements
Whether your coating operation is electrostatic or
nonelectrostatic, manual or automatic, over 1,200 Nordson
Cross-Cut nozzles in a wide range of nozzle types, spray
pattern widths and flow rates are available, or can be customdesigned, to meet your specific application requirements.

Nordson Cross-Cut nozzles produce greater atomizing
energy at a given fluid pressure. This provides better
control and less waste for maximum material efficiency
and utilization.