GK-189-045, Kat II All Position Travel Carriage0 pages

Gullco International Limited
21568 Alexander Rd.
Cleveland OH 44146 US
Phone: 440-439-8333 • Fax: 440-439-3634
Email: sales@gullco.com • Website Address:www.gullco.com

Item # GK-189-045, Kat II All Position Travel Carriage
Kat II All Position Travel Carriage
This system* incorporates everything required to automate your cutting/ welding operations...quickly, easily, economically.
It is comprised of the Kat II travel carriage and rigid 8 ft. (2438mm) straight track and torch or gun holder assembly. The
carriage travels in a forward or reverse direction (vertical or horizontal) on its track, moving the torch or welding gun along
the pre-set path at precisely controlled speeds. The accuracy, uniformity and quality of the cut or weld is improved.
Productivity is increased. Costs reduced. It is important to note that the Kat II carriage is not designed to travel on radius
roll formed track.
*The carriage and accessories that make up this system (see reverse) can also be purchased separately
and...you can easily convert your KAT II into an excellent circle cutting machine
This Gullco accessory, comprised of undercarriage, radius arm and centering pin, eliminates the need for track. The travel
carriage is readily fitted on the top of the undercarriage. Its drive system engages the undercarriage gears...moving the
assembly in a forward or reverse direction at desired cutting speeds along a perfectly circular path. A slide lock on the
radius arm allows fast, easy adjustment of the circular diameter.
The Gullco Kat II Travel Carriage is combined with an appropriate series of accessories to provide either the Torch Cutting
Package or Welding Package. The following briefly describes the Kat II carriage:
KAT II Carriage– Model GK-189-045
A light duty, all position variable speed travel carriage with electronic drive, dynamic braking and speed potentiometer
providing infinitespeed selection within the range of 2-45 ipm (5-114cm/min.). It is equipped with Forward/Reverse switch,
Run/Stop switch, 1 amo, slow-blow fuse, and “power on” pilot light. The carriage is designed to run only on rigid, straight
Kat track. It has a vertical load capacity of 50lbs. (23 kg.)
Safety is assured by the use of Gullco’s low voltage, (24 volt D.C)highly advanced control/ power supply system that is
available in three line voltage inputs...42, 110, and 230 volt A.C single phase, 50/60 Hz. Specify line voltage required
when ordering.
Model GK-184-200 Circle Cutting Accessory
Includes: Not Shown
Undercarriage:
-equipped with gear assembly that is engaged and driven by carriage gear system. Also has a clutch that allows freewheeling during set-up. Radius arm– 36” long
-with slide/lock for diameter size adjustment.
Magnet/Holder for centering pin. (not shown in cover photo).

SPECIFICATIONS

W

8 3/4 in
22 cm

H

5 3/4 in
14.5 cm

L

12 1/4 in
31 cm

10/14/2013 | Page 1 of 2