Model 610 Automatic Applicator Controller0 pages

MDG-118
Model 610
Automatic Applicator Controller
The Model 610 Automatic Applicator is designed to
dispense small deposits of paste brazing and soldering
alloys or other viscous materials. Each paste deposit is
precisely measured, ensuring controlled filler metal costs
without waste.
Features
Precision digital timer and display
Program dispensing times by using push
buttons
Unique teaching function allows fast setup
of time cycles
Requirements/Specifications
Electrical:
selectable
115 or 230 VAC, 50/60 Hz., user
Air Supply: 1/4” female pipe thread inlet for
clean, unlubricated shop air at 50 psi (optional
filter/separator available)
Operates under timed or manual mode
Dimensions/Weight:
5.75”D, 5.1 lbs.
High flow solenoid valve
Vacuum: High efficiency, transducer design
Vacuum “pullback” with fine adjustment for
low viscosity materials
3.0”H x 11.75”W x
Timer Range: .004 – 99.9 sec.
Repeat Accuracy: ± 0.01%
Footswitch and syringe stand included
Cycle Rate: >600/minute
Syringe stand holds both 12cc and 30cc
cartridges
Accessory Kit: (Sold separately) includes:
(1) 3-foot plastic air line with cartridge adapter
(3) 12cc or 30cc syringe cartridges
(3) interchangeable needles with orifice sizes of
.030”, .046” and .055” (special needle sizes
available)
9-pin, D-shell connector on rear of unit
permits control by an external system
CE certified
FUSION INCORPORATED
4658 E. 355th St., Willoughby, OH 44094
Phone 1-800-626-9501 • (440) 946-3300
Fax (440) 942-9083 • e-mail: info@fusion-inc.com
Web: www.fusion-inc.com