Electric EBRO Wafer Butterfly Valve0 pages
Electric EBRO Wafer Butterfly Valve
Type: J3-6100-EB
Available with actuator function:
POWER OPEN - POWER CLOSE
J3-6100-EB
FAILSAFE
MODULATING
FAILSAFE MODULATING
J3-6110-EB
6100-EB Series
Actuator direct mounted
Actuator mounted via kit
Main J3/ J3C Smart electric actuator features:
Specifications:
LED light for continual visual actuator status feedback.
Actuator housing
UV Protected Polyamide
Fully weatherproof smart industrial actuator, CE marked.
IP Rating
IP65 (J3) or IP67 (J3C)
Multi-voltage capable actuator , EU manufactured by J+J.
Actuator temp limits
-20 to +70°C
All external electrical connections, no need to remove cover .
Assembly temp limits
J3-6100-EB +100°C EPDM
J3-6110-EB +120°C EPDM
Thermostatic anti-condensation heater.
Valve body
Cast Iron, epoxy coated
Electronic torque limiter.
Valve disc
Stainless steel
Valve liner
EPDM (NBR, Viton, Silicon, GMX option)
Valve Pressure rating
16 Bar
Valve temp limits
-10 to +120°C
Size range
2” to 12”
Selectable manual override facility.
End of travel switches for remote open/ closed indication.
Applications:
Water, and most non-corrosive media, subject to compatibility with
wetted parts in contact with media.
Electrical actuators sized on a maximum differential pressure of 10
bar wet service, operated at least once per day. If the intended duty
differs from these parameters or is dry (air or gas), call to check JJ
actuator sizing as a larger output valve actuator may be required.
Maximum working temperature of a direct mounted assembly is
+70C. For higher working temperatures , consider models that have
a mounting kit between the valve and actuator which uses air cooling to dissipate the rising heat from the valve away from the actuator. Should the J3 smart actuator see more than +70C it will malfunction.
Wafer pattern butterfly valve installation information:
How this electric 1/4 turn valve works (on-off):
Electrically operated valves are driven by a motor and gearbox.
On receipt of a continuous voltage signal the motor runs and,
via a gearbox in the J+J smart electric actuator, rotates the valve
stem. The motor stops at the desired position (usually 0° or 90°)
by internal cams striking micro-switches. The smart valve actuator remains in this position, with the voltage still applied continuously, until switched and a continuous voltage reversing signal
is applied, which runs the motor in the opposite direction, reversing the rotation until separate set of internal cams strike
separate set of micro-switches.
Wafer pattern butterfly valves sandwich between two mating flanges,
secured by through bolts that pass all the way from one flange to the
other, and a corresponding nut. See diagram to the right.
The correct alignment of wafer pattern valve so that the butterfly
valve’s resilient liner seals against the raised faces of the flanges is
aided by through-bolt lugs cast into the wafer valve’s body, although
as these lugs are oval in shape to allow alignment with several different flange standards (ANSI, BS, DIN), care must be taken to ensure
correct alignment when tightening the through bolts.
Wafer butterfly valves are not suitable for end of line service.
Uncontrolled copy, not subject to automatic updates.
Doc: J3-6100-EB-Rev0 Jan 2015
"